Error Code 583

RSS

Error Code 583

Result: SPED - ENABLE PIN ENTRY MODE FAILED

Solution:

1. Inspect the cable from the Main Board assembly to the SPED module for damage. Make sure that the cable is connected at both ends.

2. Verify that the DC operating voltages are within specifications.

3. Power down the ATM in the proper sequence. From the Main Menu screen, select System Parameters (5) followed by Shut Down the Terminal (4). When the indication that it is safe to turn off the terminal is displayed on the screen push the Power ON/OFF switch to the OFF position. After about ten seconds, push the Power ON/OFF switch to the ON position to start the terminal.

4. Clear the error. If the error persists, replace the SPED module.

Previous Post Next Post