Error Code 562


Error Code 562: SPED ERROR


1. Inspect the cable from the Main Board assembly to the SPED module for damage. Make sure that the cable is connected at both ends.

2. Power down the ATM in the proper sequence. From the Main Menu screen, select System Parameters (5) followed by Shut Down the Terminal (4). When the indication that it is safe to turn off the terminal is displayed on the screen push the Power ON/OFF switch to the OFF position. After about ten seconds, push the Power ON/OFF switch to the ON position to start the terminal.

3. If the error persists, replace the SPED module.


Previous Post Next Post